Broken Spring Replacement · New Westminster
Garage Door Spring Replacement in New Westminster, BC
A broken spring is the most common garage door call in New Westminster, and on the wet coast the spring that broke has usually been rusting for a while. The right replacement is the one matched to your door, not the one that happens to be on the truck.
Usually there is a bang from the garage, and then the door will not lift or the opener strains and quits a few inches up. Look at the shaft above the door: a broken torsion spring shows a clean gap in the coil. On older doors with extension springs along the side tracks, a broken one hangs slack. Stop using the opener; it is not built to lift the full weight of the door.
Torsion or extension
Torsion springs sit on a shaft above the door and wind up as it closes; most doors installed since the 1990s have one or two. Extension springs run along the horizontal tracks and stretch as the door closes. They must have a safety cable threaded through them, as DASMA's inspection checklist requires, so a broken spring is contained. If yours have none, that is fixed during the replacement.
What the job involves
- Weighing the door and sizing the spring to the weight, height and drum. A spring chosen by eye is why some replacements last three years instead of seven; DASMA's Technical Data Sheet 190 lists the wrong spring and the wrong number of turns among the main causes of early failure.
- Replacing both springs on a two-spring door. They have done the same cycles.
- Winding to the correct turns with proper winding bars and setting the cones.
- Checking cables, drums, bearings and rollers while the tension is off. On a damp-garage door, the bottom of the lift cable is where rust shows first.
- Balancing the door: with the opener disconnected it should stay put halfway up.
- Resetting the opener and running both reversal tests.
Rust, and what to replace it with
Standard oil-tempered springs are fine in a dry garage. In a garage that stays damp all winter, a galvanized or powder-coated spring resists the pitting that starts most breaks, and it is offered as an option rather than pushed. The standard residential spring is built for about 10,000 cycles, and Garaga's estimate of roughly 1,500 cycles a year for a typical household puts that at five to seven years. High-cycle springs with heavier wire last several times as long, and make sense on a door used as the front door.
Why not do it yourself
Because the industry whose products these are says not to. DASMA's Technical Data Sheet 167 states that all spring repairs and adjustments must be performed by a trained door systems technician using proper tools. A wound spring releases its energy all at once if a bar slips.
Frequently asked questions
How long does a spring replacement take?
Usually one to two hours on site for a two-spring torsion door, including weighing, balancing and checking cables and rollers. Longer if cables or bearings also need replacing.
Are galvanized springs worth it?
In a garage that stays damp, often yes, because rust is what starts most breaks. In a dry, heated garage a standard spring does the job. The quote shows both prices.
Can you convert extension springs to torsion?
Often, if there is room above the door and the header can take the bracket. It is a bigger job than a like-for-like replacement and is quoted as one.
Request a Quote
Call 778-900-5172 or send the form and we will get back to you within one business day.
Serving New Westminster and surrounding areas. Contact us for a no-obligation quote specific to your property.